Operation manual

Back to: PITON steerable needle

All models and source code can be found in /home/PITON/.

Start Ubuntu

1. Switch on the setup with the power button on the power socket
2. Start the computer
3. Choose the default Linux Kernel
4. Log in as PITONuser with password PIT2011

Start MATLAB

1. Open a terminal.
2. Type sudo matlab with password PIT2011

Simulink models

Targets

Two different targets are used in the following models.

Generic Realtime Target (grt)

• Target is not Realtime, although its name suggests otherwise
• Cannot be used to control the ethercat stack
• All blocks within a scheme run at the same rate
• Can be used with external mode

Multi Threaded Target (mtt)

• Target is Realtime
• Can be used to control the ethercat stack
• Parts of the scheme can run at 1/n times the basic rate, n must be an integer
• Cannot be used with external mode

Models

fireCamCalibration/fireCamCalibrationModel.mdl - can be used to position the camera with respect to the needle and to determine appropriate settings.

• Run it with external mode to view the camera images.
• The red container marks the Region Of Interest (ROI).
• Position the camera and shape the ROI such that the all markers stay within the ROI during the experiments.

src/PITONlib.mdl - contains library blocks. This model is not meant to be run as is, it is just a container for the blocks.

• Vision
  • Image acquisition from the camera
  • Shape detection from the obtained images
• Motion
  • Linear motor
  • Conversion from force to voltage
• Tools
  • Save signals to a .dat file
  • Butterworth filter

template/PITONtmpl.mdl - a working template to use as a starting point for custom experiments. Copy it to another location before building and running it.

• uses the MTT target
• vision running at 25Hz
• motion running at 1000Hz

Running an experiment

General directions

1. Build the Simulink model using ctrl+b (only necessary when changes are made or when directed to do so by MATLAB). Ensure that the working directory of MATLAB is the directory containing the model.
2. Ensure the motor enable power switch is switched on, it must be turned to the right
3. Open a terminal
4. In terminal: Enable super user privileges by typing sudo su and using password PIT2011
5. In terminal: Navigate to the directory containing the Simulink model
6. In terminal: Run ./modelname

Hold your hand at the motor enable power switch to use it as an emergency switch if needed.

Grt specific

• When running ./modelname in a terminal, add -w to start simulation from Simulink.
• When running ./modelname in a terminal, add -tf inf to discard the simulation end time and run the simulation forever.
• When using external mode, ensure MATLAB's working directory is the directory containing the Simulink model