RoPod/Tutorials/GAZEBO installation and interface with ROS

GAZEBO is a set of ROS packages that provide the necessary interfaces to simulate a robot in the Gazebo 3D rigid body simulator for robots. It integrates with ROS using ROS messages, services and dynamic reconfigure.

Install gazebo (versions 7.x are compatible with ROS kinetic): http://gazebosim.org/tutorials?tut=install_ubuntu&cat=install

curl -ssL http://get.gazebosim.org | sh

Install gazebo_ros_pkgs and some extra packages needed to run the basis ropod model

sudo apt-get install ros-kinetic-gazebo-ros-pkgs ros-kinetic-gazebo-dev ros-kinetic-gazebo-plugins ros-kinetic-gazebo-ros libgazebo7-dev libgazebo7 libignition-math2 libsdformat4
sudo apt-get install ros-kinetic-gazebo-ros-control
sudo apt install ros-kinetic-joint-state-controller
sudo apt install ros-kinetic-effort-controllers
sudo apt-get install ros-kinetic-openni2-camera ros-kinetic-openni2-launch

Get familiar with ROS and with the catkin_make way of working: http://wiki.ros.org/ROS/Tutorials/InstallingandConfiguringROSEnvironment

Now we will install existing ROS and gazebo files that will allow to perform simulations of the ropod

Ensure you configured GitHub and you have downloaded the repository: See tutorial

Now you are ready to start the ropod_gazebo model plus the ROS packages to interact with it.

The first time you install the files in your computer be sure that the folders ‘build’ and ‘devel’ are removed, as well as the file src/Cmakelists.txt

Then, on the main directory level, run a cmake command to generate the executable files

catkin_make

Then, we can launch the ropod gazebo model, which is already connected with ROS

roslaunch ropod_gazebo ropod_world.launch 

Get familiar with the data being published, the nodes, etc. See ROS tutorials

Matlab and GAZEBO interface via ROS

Open the file ropod_controller.slx. Before executing the simulink model, launch the ropod_gazebo model.

Now you are ready to start simulating your own controller.