Embedded Motion Control 2019 Group 1

Group members

1. Toos van Gool
2. Paul Janssen
3. Jochem Manders
4. Max van Meer
5. Raoul Surie

Design Document

An initial design report was created to assist in the design of the software, which can be found here: 4SC020_Embedded_Motion_Control_Design_Document_Group_1.pdf. The parts from the report can also be found here on this wiki.

Introduction

The information structure proposed in this document is used to design the software of an autonomous robot, named PICO. PICO has to complete an escape room challenge and a hospital room challenge. To ensure good performance in these challenges, the requirements and specifications are defined initially. Afterwards, the hardware and software components are identified and the functions of the software components are defined. Finally, the interfaces between the components and functions are explained.

Requirements

In progress

Components

In progress

Functions

In progress

Specifications

In progress

Interfaces

In progress