Embedded Motion Control 2019 Group 8

Group Members

Names:	Student id:
Stan den Hartog	0953184
Elise Verhees	0950109
Rob Dorussen	0968849
Gosse Bijlenga	0950642
Max van Haren	0953564

Requirements

1. Autonomously exit the room within 5 minutes in two trials.
2. Must not bump into the wall.
3. Must not tip over.
4. Make sensible movements/progress each 30 seconds.
5. Software must be easy to set up.
6. Robot must function robustly.

Specifications

• Rear wheel must be over the finish line.
• Distance between the wall and the robot must be 0,05 meter.
• The maximum translational speed is 0,5 meter per second, the maximum rotational speed is 1.2 radians per second.
• The robot must have a maximum speed/stop before changing direction.
• The maximum inclination angle is around 5 degrees.
• The software must have 1 command to update, compile (cmake/make) and start executing.
• The status must be reported at least each 30 seconds.
• The functions must be scalable.
• Switch states only to advance the strategy plan.

Functions

• Detect if the robot is over the finish line
• Drive forward (keeping the speed specifications in mind)
• Rotate
• Collision detection
• (Update World Model)
• Print status
• Scan environment for exit
• State function/ Life Cycle State Machine (LCSM)
• Wall hugging

Components

1. Room
   1. Walls
   2. Finish line
   3. Exit tunnel
   4. (Obstacles)
2. Robot
   1. Actuators
   2. Sensors
   3. Body
   4. Hardware
3. Software
   1. World Model
   2. Interfaces
   3. Plan
   4. Actuator control
   5. Monitoring
   6. Preception
   7. Mediation
   8. Life Cycle State Machine (LCSM)