Embedded Motion Control 2014 Group 8

Harm van Deursen
Lex Hoefsloot
Paul Verhoekx
Teun Melief
Robin Smit

PICO Knowns

1. 1080 laser points for distance measurement
2. approximately 250 degrees of measurement direction
3. The datapoint at the left (930), front (540) and right (150)
4. The maximum distance measurement is 30 meters
5. ...
6. PICO's velocity and angular velocity can be determined. These are in meters per second and radians per second respectively.
7. ...

The figure on the right shows the location of the laser (distance) measurement points

First test

The first goal was to survive the corridor test. This means any corner, left or right, should be detected and taken without any collosion.
There were two main tactics to be tested;

Global tactic (inserted in both programs):
- The corner can be detected by either laser point #150 or #930.
- Safety (not hitting the wall) is inserted for the measurement points 150 - 250, 400 - 540, 540 - 680 and 820 - 970.

first tactic:
1. The distance in front is measured and saved when a corner is detected.
2. Than PICO starts rotating until the distance on the side where the corner has not been measured is equal to the distance that was previously in front
3. PICO drives sidewards until the distance is 30 centimeters less
4. pico drives straight ahead again. The corner is taken

Second tactic:
1. The corner is measured but PICO keeps on driving straight ahead and the timer starts
2. The end of the corner is detected and the timer stops
3. PICO drives backwards for half of the time the timer has measured
4. PICO drives sidewards through the corner
5. PICO turns to get back in its neutral position

Observations;
- All measurement points should be used for safety to ensure safety
- The big mess should be cleaned and divided into seperate files which will be included into the master file
- One point to measure a corner is not robust. This should be done by the use of more points.

However, the second tactic seems to work quite okay and will thus be used for the corridor competition

Corridor test

Unfortunately there was not enough time to implement the observations in the code. The second method is used and led to a time to pass the corridor in 32 seconds.

second test

................................

Master

...... [All] ......

Driving straight

...... [Harm] ......

Drive safely

...... [Robin] ......

Detect a corner

...... [Robin] ......

Take the corner

...... [Robin en Paul] ......

Arrow detection

...... [Teun en Lex] ......

Algorithm to solve the maze

...... [Paul] ......

It's a new world

How to load the T-junction:

1. Open Terminator
2. Run:

    gazebo maze/placearrow_Tjunc.world 

   when in the maze folder
3. In another terminal
4. Run:

   rosrun maze spawn_Tjunc

5. and run:

   roslaunch pico_gazebo pico.launch

   to load Pico
6. Now you can run Rviz:

   rosrun pico_visualization rviz