Printer Casus Ebox/Experiments manual

Instructions for measuring and controlling the experimental HP printer setup, corresponding to the case of "The Print Head" (4G031)

This manual describes the necessary hardware # and # Software for measuring and controlling the experimental HP printer setup used in the case the Printhead (4G031) is used, are discussed. The section # Start-up experiments and includes an introduction to the use of the preparation and the actual execution of experiments. To use a setup that you subscribe to the appropriate registration lists in sel3. This should be your group each time up to 1 time for 1 time setup register. On the desk in sel3 you can borrow the necessary TUeDACS and accessories. Almost every day, for several hours assistance available in sel3 where you can store your questions. The hours of care is available, are indicated on the registration lists. For questions and during the experiments, please contact Geert-Jan Heldens ( , Wh -1.13 (DCT-lab)). The project coordinator is Rene of Molengraft ( , tel 2998, Wh -1141).

Hardware

The case is a stripped A3 HP printer, see Figure 1. The required hardware for the experimental set-up is included in Table 1. You have to take your own notebook to do experiments.

Figure 1

Required hardware

1. Notebook with E/box image installed
2. Experimental HP printer setup (see Figure 1) including cables
3. Amplifier including BNC cable

Table 1

I/O Printer	I/O Versterker	I/O E/box	I/O Notebook
Motor input	LOAD
Encoder output		Encoder 1
End-switch I/O		DIGITAL I/O
	+/ − 2, 5 V in	Analog out 1
		Ethernet port	Ethernet port

Table 2